On the first image the link is up at 20/40Mhz Ce before 22:00 saturday, after that time is at 20Mhz On the second image the second link is up at 20/40Mhz before 8:15 sunday and after 14:00, in between them the link is at 20Mhz There is no interference or noise. Conclusion: tx-power not stable on 911...

Has the problem solved?

- Dude 3.6 shows not correct value about CPU load
- upgrade from 3.30 I can't update licence key: I have to downgrade to 4.11, update licence key, then upgrade to 5 RC3

I would be nice that in /ip service I could set more ip address or one addres-list

Thanks for info. Would you send me your email or other contact for further questions?

kozmai

RouterOS handles dhcp for cm and cpe in our case. We do run several types of CMTS (Cisco, Arris, Motorola). In Cisco IOS you should make sure that you activate "cable dhcp-giaddr policy" on the cable interface. With this RouterOS is able to choose the right network for cm and cpe, for ins...

Would you tale more about your system with mikrotik?
Does the RouterOS handle dhcp requests both clients and modems? Is the leases static for modems or dynamic via radius?

ThX

thx

How can I disable switch function or remove port from "switch"?

I have found the problem. There is a command in the read function of routeros_api.class.php file: echo "$BYTE\n";
I have commented and the problem is gone.

I have a simple api script in php $api->write('/interface/wireless/registration-table/print',true); $array = $api->read(); $api->disconnect(); after I wrote here some code that draws a html table and put data into the table. The problem is, after $array = $api->read(); command, lot of numbers appear...

I don't understand why mikrotik os use ip rather the fully qualified domain name. We have had to change the one of radius server ip. I had to change this in more then 100 router. When I change the radius ip in mikrotik as radius1.mydomain.com, it is converted to "1.2.3.4" WHY??? I have sho...

Thank YOU!

Cmon, I have written a schema, not a WORKING script. Your "example" is very far from I like to do. I think You didn't understand the main problem.

while (/ip route where dst-address=0.0.0.0/0 is gateway=abcd) do={
if ([/ping abcd count=5] < 1) do={
/ip route set [find dst-address=0.0.0.0/0] gateway=dcba;
}
}

So I like to change the gateway to dcba when the abcd is not answer. But I can not do the row no.1

How can I script the following problem:

while (ip route [where dst-address=xyz] enable) do {
}

So while one of row of the routing table where dst-address=xyz is enable, do something

I would like to build cable operator machine with mikrotik to serve cable modems. Every services are in mikrotik excpet TFTP server for booting cable modem and ToD (Time of Day). Would you put these in mikrotik os?

thx

There are two networks on a same physical interface. How can I make that both networks can get ip addresses from MikroTik?

I have a problem. In the interface menu the traffic meter of the TX rate of wlan1 card shows higher traffic then the RX rate of ether1. The ether1 link to ISP, wlan1 is tx card of the nstreme. I think the RX rate of ether1 should be approximately equal to TX rate of wlan1.
Any idea?