No other card requires any extra settings to allow change to 5GHz ....
What can I do to force it to use 5 GHz ?

0 interface-type=Atheros AR5413 chip-info="mac:0xa/0x5, phy:0x61, a5:0x63, a2:0x0, eeprom:0x5003" pci-info="00:12.0" capabilities=tx-power-control,ack-timeout-control, virtual-ap,alignment-mode,noise-floor- control,scanning,burst-support,nstreme, sniffing,power-channel,wmm defaul...

MMM MMM KKK TTTTTTTTTTT KKK MMMM MMMM KKK TTTTTTTTTTT KKK MMM MMMM MMM III KKK KKK RRRRRR OOOOOO TTT III KKK KKK MMM MM MMM III KKKKK RRR RRR OOO OOO TTT III KKKKK MMM MMM III KKK KKK RRRRRR OOO OOO TTT III KKK KKK MMM MMM III KKK KKK RRR RRR OOOOOO TTT III KKK KKK MikroTik RouterOS 3.14 (c) 1999-20...

1 name="wlan1" mtu=1500 mac-address=00:60:B3:AC:AB:74 arp=enabled interface-type=Atheros AR5413 mode=ap-bridge ssid="MikroTik" frequency=2412 band=2.4ghz-b scan-list=default antenna-mode=ant-a wds-mode=disabled wds-default-bridge=none wds-ignore-ssid=no default-authentication=yes...

Hello everyone, I've purchased a q-ty of AR5414 cards for 5GHz links, chip says AR5414, but microtik says it is a AR5413 card and it doesn't run on 5 GHz. The documentation says that this chip is supported, and I've seen posts of people using it. here is the picture of the card: http://i22.ebayimg.c...