Ashish ... How about this one ????

That's a piece of art Spice_prash! Can you tell us a bit more? HTML editor you used?.. techniques?

Again: great job

Doesn't work.

Just like on ether1, it worked on ether2 for a few minutes and then quit.

i'm quitting as well. Going for a non-mikrotik solution.

thx for all your input

Indeed the firewall is on ether5.

ether1 i used for(the first) vlan (together on a bridge like you suggested)

From what i can deduce till now is that switch mode is not functional unless you specify a masterport for 1 or more interfaces. (read same document) But i'm still nowhere with this. Last night it worked for 20 mins, then all traffic stops. this was on the RouterOS 4.7 change log: *) fixed problem - ...

Could this be part of my solution?

http://wiki.mikrotik.com/wiki/Manual:Sw ... p_Features

if so, which vlan mode should i use?

updated to 4.7 this time it worked a little longer. About 25 min, and then all traffic seized on the vlan and it's masterinterface. One thing i noticed is that the masterinterface in pfsense showed exactly the same bandwidth pattern of the vlan10 that is attached to it. Whole thing worked perfecty w...

Will do. Thx

Don't know what i did wrong or right, but after switching vlan10 around between the pfsense nics (though that maybe the nics on pfsense were a problem), while torching port5 on the RB (while it was "again" on the bridge) i suddenly saw traffic on vlan10, so i quickly removed port5 from the...

Torch reveals zero traffic on vlan, with or without port5 on added to the bridge. (all options enabled in torch)

When ethernet port 5 is removed from the bridge, all traffic stops.

Great tips! I'll work on it tonight and post the results

Could you explain what torch does?

The setup i'm going for is:
modems -> mikrotik RB750(with vlans) -> pfsense firewall(with vlans)-> LAN

On port 5 of the mikrotik i have the Pfsense firewall, in which i've configured vlan10.

On Port 1 of the mikrotik is an adsl modem. Not using DHCP, but added ipaddresses to port5, port1, vlan and bridge in the same range of Vlan10 and modem

Not quite there yet.. First of all, if i watch the virtual interface in pfsense i get a small amount of outgoing data (max: 100kb on a 512kb line), and no incoming, while the Actual WAN interface it is linked to does show normal incoming and outgoing traffic(in pfsense). Note that the actual interfa...

Hi Feklar, Assuming that i understood you correctly, i created 4 VLANs (attached to port5). Then i created 4 bridges (rstp), each with 2 ports: 1 VLAN + 1 physical ethernet port. I can't ping from/to port 5 from/to any other port. (hooked up 2 laptops for config). Even added IP addresses (in same ra...

Thx Feklar.

Let you know if i succeed.

Hello, I have a pfsense (version 1.2.3) server PC mainly for loadbalancing purposes because of internet-pricing issues. Runs without problems. However i've run out of pci ports on the pfsense pc, but need more WANs. I assume utilizing vlans is the next step. For this i've acquired a mikrotik routerb...

Hi Nilesh,

If the wireless cards (you want to have a single SSID) are on the same mikrotik board, do you still do it with WDS?
And if so, with each other's mac-addresses as well?