when i try to add or remove an EOIP interfaces to a Bridge, all the PPPoE tunnels (also the ones that belong to the others EOIP tunnels) keep disconnecting

RB1000
RouterOS 5.18

hello, i have a fully-routed network and bts are on layer2 to core-router trough some EoIP tunnel. All EoIP tunnel are bridget in "bridge2". PPPoE server is attached on same "bridge2" with public IP pools (dynamic allocation). 'cause i have only public /24 i use proxy-arp on eth1...

tested on rb450g:

- create a bridge1
- add ether1, ether2 on bridge1
- delete (no disable) bridge1 without remove first ether1,2 from bridge ports

- go to interface/ethernet ether2
- try to set master port ... router os says that port is already in bridge

bye

i also have this issue on winxp fresh installed

same winbox.exe at another pc on same routerboard work fine.

explorer.exe and winbox.exe run both as admin

Some ubiquiti icon for the dude.
Attach yuor own

bye

ok thanks
i'm going to test this:
rb 1000 --> rb750 --> intel core2 with router os

hi, i've connected two rb750 (router os 4.5) with 1 utp cat5 (30 cm). I deleted the initial configuration. I set only one Ethernet interface on both routers and I have connected with an ethernet cable. With the bandwidth test on Winbox (tcp), i see 46Mbps rx and 44Mbps tx (once per time). With udp: ...

Hi, I think there is an error in http://wiki.mikrotik.com/wiki/MPLS_Lab_Setup PE1 /ip address add address=10.1.0.1/24 interface=ether1 PE2 /ip address add address=10.1.0.2/24 interface=ether1 PE3 /ip address add address=10.1.0.3/24 interface=ether1 I think it should be: PE1 eth1: 10.1.0.1/24 PE2 eth...