Hi, I'm running a router configuration where I've got routes for a same networks learned via RIP and also I've got static routes towards the same networks installed with higher administrative value. This with the aim to route traffic towards a specific network through information learned by RIP and ...

This is sorted out, according to support this is a bug. See below. Hello, Thank you for reporting this problem. It is detected and will be fixed in next RouterOS releases. Regards, > Hi support, > > I've bought a brand new RB1200 router and configured it in a way where ports > eth1,eth2 are routing ...

I have no output at all from the console port. Any other idea.

Hi, I just bought a brand new RB1200 router , created a simple config (ROS 5.2) and after I issued a command to restart it never comes back online again. Tried mac-telnet to access it but not successful. The indication is it is not booting at all any more. Does anyone have information or experience ...

Hi, Has anyone had the experience in which the RB493AH halts in situation w/out high load or users. When this happens access to the router is no more possible while physically are router LED's are shut down. In order to remedy this I have to disconnect power from the router for a few minutes and the...

I've noticed that while using the terminal inside the winbox session and pressing tab command for command completion the behaviour is strange e.g. /system ssh user[then pressing TAB to complete the word user=] I get 'user%'. Anyone noticed this ?

Yes I'm in CET time zone, I will report this to MT, there are just too many inconsistencies noticed until now while using MT for 1 week. I've also noted that when I make a change of a peer configuration in ip->ipsec->peers all the active established connection with all peers are restarted. Have you ...

Hello, I've noticed that the 'addtime' parameter extracted from the command ip->ipsec->installed-sa print is one hour behind. The routeros version is 4.13 and system clock is is synchronized via NTP. [admin@MikroTik] /ip ipsec> installed-sa print 5 E spi=xxxx src-address=x.x.x.x dst-address=x.x.x.x ...

Hello, I changed the winbox service default port via ip->services command but when I tried to connect via winbox client to the mt box where the changed was applied I noticed that the connection attempt was still toward the old port and the connection failed. The routeros sw version is 4.13. Any idea...