Do not ask how to configure,
do yourself.
There's 3 slots that mean 3 Radio cards can support! there's no problem with other 433AH(s).I don't think having 3 X radio cards in one board is a good idea as interference will cause a issue,
chain=prerouting src-address=192.168.0.140 action=mark-connection new-connection-mark=GroupBC passthrough=yes
chain=prerouting connection-mark=GroupBC action=mark-routing new-routing-mark=GroupB passthrough=no
1 chain=prerouting action=mark-packet new-packet-mark=conn passthrough=no packet-mark=connection
/ip address print
/ip route print
export
Yes it is. In standard iBGP, split horizon rules will help to achieve this. but when you are using route reflectors in AS(s) there's difference.iBGP does not guarantee loopfree routing
/ip route print where !bgp !ospf
Are you sure the router's wireless card is in AP-Bridge mode!?!?any one don,t know that how this option active?
if i understood, you want to assign 192.168.254 to the interface which connected to 192.168.1.1 but you want 192.168.1.2-253 be not in your subnet mask? i understand correctly?i want to create ip with only one port not 254 and i have gateway with 192.168.1.1 how to make 192.168.1.254.thanks
/system reset-configuration
I saw this before, because of very low bandwidth on encryption mode (with some carrier in some countries because of some fuc... gov... policies ), appear of winbox buttons and lists is not correct.I don't understand how this can help with my problem
I didn't think like that! I just designed it on free time as a little gift!epic
/ip firewall nat
add action=masquerade chain=srcnat disabled=no dst-address=!192.168.1.11 \
src-address=10.0.0.0/24
/ip firewall nat add chain=dstnat protocol=tcp dst-port=80 action=dst-nat to-addresses=X.X.X.X to-ports=80
I didn't say on specific ethernet port, I asked are there any bridge?no , i Don't Have any Bridge on Ether 4 (That Ether Connect to a Switch and Servers)
That's right. but about user's antenna, my purpose was our Access Points!No, I think each user connected to a ppoe server, receive an ip address. This ip is "connected" to the server and can be pinged.