Hi, I tried upgrade my RB2011 from ROS6.0 to 6.1, but it can't boot, lcd stay on "starting service", I use console to check it, it show below error: verified ntp-6.1-mipsbe.npk verified routeros-mipsbe-6.1.npk installed routeros-mipsbe-6.1 installed ntp-6.1 Restarting system. RouterBOOT bo...

Hi, I just update my RB2011 to 6.0RC7, and find when I use " [/ip address get [/ip address find interface=ether10 ] address]" it show error input does not match any value of actual-interface , but that is no problem in 5.22, I use "/ip address print detail", all interface and act...

Some new finding, I turn off the RB2011's wifi and turn my old TP-Link 1043ND, it can connect without any problem, but I switch back to RB2011's wifi, can't connect. The SSID, WPA2's key, ciphers is same New finding, if I change the channel width to 20/40MHz HT Below, it can connect, but before usin...

There is no log message on connect, I enabled the debug to memory. So don't know is what happening.

It is no problem on Win7, only got problem on win8, tried win8 built-in driver and updated to Atheros V10.0.0.75_21 got same result. The wifi on notebook is Atheros AR9287.

Alan

Hi Normis, In win8 it can see the access point, after I input the WPA2(tried use WPA1 instead it, same result) key, after around 20-30 seconds, win8 show can't connect, I checked the windows event, the message is the AP no response, I tried turn on debug on RB2011, then no any log message show when ...

Hello,

I just upgrade my laptop to Win8, it can't connect to RB2011's wifi, but before upgrade is no problem, any one got the same problem??
My laptop is using Atheros AR9287

Thanks
Alan

After added the regedit, SSTP work again!!

Thanks a lot!

I got the same problem, but the windows error code is 631, I'm looking for how to solve too.