Thank you for taking note of those steps. When I reset my unit, I had done those exact steps as well. I do see that IP in the ARP table as well, but still cannot ping.
Thank you for your reply. I have tried doing as you say to no avail. I have also tried to reset the device and use a default configuration and that did not work either.
Hi Van, Thank you for your information. I tried as you said and have spoken with the carrier and still have not come to a resolution. As you stated, I can see in the packet sniffer with no ports an ICMP ping, but no reply. I would lean to say that something is wrong with the carrier, but the fact th...
Hi Van, Thank you for your reply. When I have chain=srcnat action=src-nat to-address=1.1.1.1 src-address=10.1.1.0/24 enabled, I get the expected output in the packet sniffer that you describe below. I have lines, among other, that state: interface -> ether1-gateway direction -> tx scr address -> 1.1...
Hi and sorry for my delayed response. I thought I subscribed to the thread, but I did not recieve an email. I tried what you suggested below, but to no avail. I also tried disabling all the NAT enabled and just using chain=srcnat action=masquerade to-addresses=0.0.0.0 out-interface=ether1-gateway, w...
I am having an issue pinging the default gateway on my network. If I configure the interface using DHCP, I can ping the default gateway telling me that it is connected properly. If I remove DHCP and configure it manually, I can no longer ping the default gateway. When I configure a laptop with the s...
I seem to have figured it out. Or at least on Windows. On Windows I used the -p switch to make the route persistent across reboots, and I used the if parameter to make this route monitor when the interface is up or down. It works as planned, is added when the interface comes up(VPN) and removes it w...
Hello all, My issue is I need to push a route to the client when they connect to the L2TP/IPsec VPN. ROS does not support this and will not until Version 6 with mode-cfg. Unfortunately I need it now. I emailed ROS support and he suggested that I add a route to the client, which when I do that it wor...
If this is a feature that you are thinking about implementing, it would be nice if we could have a SFP slot so that we could use any that we wanted dending on the current installation needs.
Hello, I am looking to build a WDS network. I want to have all of the back-hauls over copper, so no mesh, just wireless distribution with 2.4gHz radios. If this is all set up properly, how much wireless client active roaming will be able to be done? How long does it take the user to switch to the ne...