Due to the RB4011 is not stable in v6.45 and V6.46, I want to try the long-term v6.44.6.
I had try the official download web page, but always got "404 Not Found"

No we haven't. A) Because we couldn't get the seller to even respond to an out of the box power supply failure. And Mikrotik won't handle the warranty directly. B) I really don't believe it's a hardware problem. Totally agree your opinion, after downgrade routeros to 6.43.7, the problem seems disap...

I have many of RB4011 and RB1100 AHx4, some of them encountered the same issue in this week. No matter use 6.46, 6.46.5 and 6.45.8. Currently, I scheduled an on/off snmp every 6 hours and also set cpu to 1200Mhz. Hope it help. /system schedule add interval=6h name=ResetSNMP on-event="{\r\ \n/sn...

RB850Gx2 will be crashed by a kernel failure if run Bandwidth Test in TCP both direction mode.

I have the same problem, too.
CCR1016-12S-1S+
RouterBoard booter 3.22
RouterOS version 6.27

Dear sir, I bought a new Mikrotik RB450G these days. The original software version is 6.19. I want to use the last version of 5.x. After downgrade to 5.26 and reboot, I found the software ID was changed and the license level was reset to 0. ??? If I upgrade the same RB450G back to 6.19, the license ...

Hi, I tried and got the same problem. I have RB450G(Home) & RB2011(Office), software are both ROS v5.26 all setting follow the official document : "Site-to-Site PPTP" as below link http://wiki.mikrotik.com/wiki/Manual:Interface/PPTP Laptop can only reach PPTP remote (172.16.1.1) but ca...

Great!!! This bug was fixed on version 5.18.

Send it via support@mikrotik.com

Done. If get any progress, I will report here.

/system check-disk

Do a supout.rif and send it to Mikrotik.

I tried to send supout.rif to Mikrotik support, but always got the message "Invalid supout.rif file."
But the same supout.rif file can be uploaded by Mikrotik supout.rif reader page and looked normally.

what happens if you put the npk files into the router under files and reboot?

Get the same error as using netinstall.

what you see in /system resources and i did not understand, you re-installed it using netinstall tool? can you install 5.14 on the board using netinstall? Yes, after upgrade 5.14 fail, I use netinstall to install 4.17, it is OK. I did use netinstall to install 5.14, but it's always show ERROR: inst...

I have the same problem, too. I try to overdrive RB450G to 800MHz, but it become unstable.

I have more than 50 sets of RB450G. All of them are working stable over 1 years. Recently, I use netinstall to upgraded RouterOS from 4.17 to 5.14. Most of them are working properly as usual, but one is crashed. I always got an error messge "disk is too small" in the installation stage. Af...