this is only temporary solution. Now i trying, how to put on ppp tunnel public adress , in past i have problems with some web pages in case when i use MTU 1480 Unreleted to this thread, But for MTU issues don't forget the MSS Clamp Rule to make packet smaller if needed. /ip firewall mangle add acti...

I made little change, which works better for me . With previous script, i have problem with deleting after disconnect #IPv6Up :delay 1000ms :local interfaceName [/interface get $interface name] :log info [/interface get $interface name] :local ipv6pd [/ipv6 route get [find gateway=$interfaceName] d...

If anyone needs "Delegated-IPv6-Prefix" to work I have a small workaround but it is a nonstandard configuration. For it to work you need to meet the following: Configure other PPPoE Servers (eg. CISCO) to ignore the "Framed-IPv6-Prefix", on these devices assign a local-link IPv6 ...

My Company just recently bought a RB1100AH with the assumption that it has 512mb on-board NAND memory Chip. However ours out of the box it states it only has 41.7MB. We have upgraded it to ROS 5.11 and Firmware 2.38. What is it that we are doing wrong? uptime: 1d22h9m3s version: 5.11 free-memory: 1...

I've been seeing some IPSec issues for quite a while now. I have managed to capture some logs during an outage 14:13-14:32 Internet was not affected during this time and other IPSec tunnels remained online during these tunnel outages. This tunnel is stable 99% of the time. Has anyone seen this sort ...

For the last few versions I've been having IPSec issues, Looks like a missing default group that is causing it Notice no * flag exist on the default group [admin@PRIMARY-ROUTER] /ip ipsec policy group> print Flags: * - default # NAME 0 group2 1 group1 2 default This causes problems with L2TP generat...

config info that might be useful /ip firewall filter add chain=input protocol=icmp add chain=input dst-port=1723 protocol=tcp add chain=input dst-port=1723 protocol=udp add chain=input protocol=gre add chain=input protocol=ipsec-esp add chain=input comment="BTest TCP, Winbox." dst-port=200...

Hi, Just looking for a bit of advice , we have created an ipsec tunnel between a fortigate and a microtik which establishes correctly. From the microtik side I can ping the fortigate and devices on its network. From the fortigate side I can ping the microtik but cant get a response from any other de...

I've been trying to figure this problem out for the last week. Funny that switching to OpenDNS server resolves the issues but my external traffic is routed incorrectly because of it. It looks like the IPv6 package that is causing problems. The PS4 seems to be very active in using IPv6 if supported o...