Probably, managed to do it, Guide helped, but at the same time didnt . What I did (I hope in case it is right to help others as well) I am describing below
-
Create a new bridge, name it as you want (I named mine bridgeVlans) and before pressing ok make sure that VLan Filtering option is unchecked
-
Create a new VLan (based on the newly created bridge) with options as below
Enabled → ticked
Bridge → bridgeVlans (the one I created)
VLAN IDs → 40 and 50 (with the down facing arrow at the left side, you can add as many as needed)
Tagged → ether18 (the one with the physical connection to pfsense coming from igb2 carrying VLAN40 and VLAN50)
→ ether17 (the one that I will connect physically with Access Point, so I want to transfer both vlans 40 and 50 tagged)
Untagged → ether19 (this will be the access port for any of the 2 Vlans depending on which PVID I will give afterwards to it’s option page)
Current Tagged ether18 (those ports will show up only if you have made already the cable connections between the router - switch)
ether17
3a. Go to ports tab and edit port 18 (the one physically connected to pfsense), port 17 (the one i want to physically connect with Access Point so it has to contain same vlans as port 18 which are vlan10 vlan) and change the option Bridge → BridgeVlans (the new you created).
3b. Go to port 19 (that will be the access port) and change the option Bridge → BridgeVlans (the new you created) and PVID to
40 if you want each device connected to port 17 to be assigned with vlan40 (for example 192.168.40.0/24) ip segment range, or set it to 50 if you want each device connected to port 19
to be assigned with vlan50 ip segment range (for example 172.16.50.0/24).
- Last but not least, go to newly created bridge (bridgeVlan for me) and enable VLan Filtering option (Apply and ok)
That’s it!!! Now Access point can broadcast bot valns with their corresponding SSIDs, whatever device I connect to port 19 (my currently only untagged one) will give teh connected device the ip according to what PVid number I gave to that port earlier (that would be 40 or 50).
Now the weird (at least for me things)
-bridgevlans traffic from RouterOS page bot at Tx and Rx is always 0 even if at that time running speedtests / downloading from clients.
-At Vlans window page it seems that along with bridgevalns I have created with VLAN IDs 40 and 50, one extra show up with the same name bridgevalns and VLAN IDs 1 and Current Untagged ports
bridgevlans, ether18, ether19. Is it because the specific ports have as PVID 1 ??? What should I put there?