Hey All,
I was just on here the other day flaming MT for not providing WISP with the proper tools on the AP side to truely give highend quality service to our customers. I STILL have some issue with this BUT I have finally discovered a work-around for my latency issues!
I hope this will help other providers with the sane problem and for you who know this and didn’t share it - SHAME ON YOU.
MT - there should be a place on this forum for quality work-arounds when your system does not provide complete support or at least a place for disclaimers!
To make my APs - globally and with high end loads 20-40 customers per XR2 card and 2 XR2 per RB433 - on the “Data Rates” Tab on the “Supported Rates B” I UNCHECKED the 1Mbps and 2Mbps boxes and left the other two checked. On the “Supported Rates A/G” I unchecked the 6Mbps and the 9Mbps boxes and left the others checked. On the “Basic Rates B” I ONLY checked the 5.5Mbps.
Once this happened - My AP latency IMMEDIATELY dropped from 1000ms+ latency under-load to 5-10ms latency.
This works on ALL versions of firmware and especially good on the newest RC version.
BTW - NV2 kicks ass! Not usable in all connections and still learning to do p-to-mp connections 'cause there are NO AVAILABLE EXAMPLE CONFIGS AND NOBODY and I mean NOBODY has responded to my requests for one! Including MT STAFF!
OK - I’m done being mad. Still all-in-all the MT system is the best!
BTW MT - had another board fail with that “you don’t have a legit License issue” during and upgrade - sending you the supout now.
These forums have saved my ass many a time so I hope I can give back occasionally without being too much of a distraction.
Thank you All,
Rod
