RouterOS version 7.13 have been released in the “v7 stable” channel! Before an upgrade: Remember to make backup/export files before an upgrade and save them on another storage device; Make sure the device will not lose power during upgrade process; Device has enough free storage space for all Rou…

CCR1016 after updating to 7.13 not show lte interface anymore. But in USB list it showing. [image] wireless already installed At 7.12 all ok. I’ve got the same problem with a Huawei E3372h-153. I’ve also got a E3372h-320 that seems to work fine. But the E3372h-153 just disappears. It goe…

Regarding 16MB flash devices, to have possibility in future to install any new ROS versions and any supported packages for device architecture maybe MT needs to consider feature to extend system partition with external drive or even possibility to completely use external drive partition as system ro…

I tested this version on my CCR 1016 where MPLS and VPLS {LDP} is running. After 3 to 5 minutes router reboots and it keeps repating over and over. On version 7.12.1 everything is ok. Has anyone same experience? No error in log.

small note outside the version. . . hap ax2 if it had at least USB2 (better USB3.X) it would be an ideal small device and I think its sales would increase several times. . . This way we have ac2 with USB but little storage space and limited RAM, and ax2 without USB but with lots of RAM and enough s…

small note outside the version. . . hap ax2 if it had at least USB2 (better USB3.X) it would be an ideal small device and I think its sales would increase several times. . . This way we have ac2 with USB but little storage space and limited RAM, and ax2 without USB but with lots of RAM and enough…

Setting connect-priority=0/1 ensures connections to a new AP are immediately accepted and the old AP connection is dropped automatically. When using PSK authentication, this allows seamless roaming even without FT. Thanks for the tip, man. You are a lifesaver!

I tested this version on my CCR 1016 where MPLS and VPLS {LDP} is running. After 3 to 5 minutes router reboots and it keeps repating over and over. On version 7.12.1 everything is ok. Has anyone same experience? No error in log. Here the same, i have a RB5009UG+S After upgrade it keeps rebootin…

Another issue: I tried to downgrade to version 7.12.1 and also doesn’t work!! I just uploaded the RouterOS 7.12.1 ARM64 into the /files of my RB5009 and went to System → Packages → Downgrade and the router refuses to downgrade. Reboots and nothing happens!. I am so annoyed! and first time I have…

After upgrading to 7.13, the connectivity to CCR1009 router was lost. After inspection, it seems that Bridge VLAN Filtering behavior has changed and is not correct. There are all VLANs declared in the Bridge/VLANs table but the VLAN filtering wasn’t enabled on the bridge. Still, the traffic wasn’…

Is anyone trying IS-IS cli? is it good?

v7.13.5 [stable] is released!

Announcements

andriys December 17, 2023, 6:30pm 188

Thanks for the tip, man. You are a lifesaver!

7.13 WiFi-CAPsMAN, Access list to assign VLANs and FT issue

Finally success - 802.11r/k/v fast roaming works reliably with WifiWave2