I would like some help setting up a vlan on my RB750r2 switch chip, I'm a noob when it comes to Mikrotik but have a good understanding of some networking areas.
I've spent a good few hours try to get this to work different configs including mikrotik wiki which kept throwing up issues.
My setup at the moment is basic as I used the Quickset config-
Eth1 DSL PPPoE
Eth2 switch 1 Master
Eth3 switch 1
Eth4 switch 1
Eth5 switch 1
I'm not 100% as to what type of port (access/trunk) needs to be assigned to what Eth!
I would like the following config if applicable.
Eth1 - DSL PPPoE
Eth2 - vlan1 internet access
Eth3 - vlan1 internet access
Eth4 - vlan1 internet access
Eth5 - vlan20 internet access, inter-vlan routing with eth 2,3,4
Would be easier not using switch chip eth 2-5?
Any help appreciated.
Thanks