I have home network configuration as shown below.
I have configured RB250GS , made trunk ports to RB951 (main router).
But i have stoped getting further in configuring VLAN switching in RB951.
if i create a vlan with id 3 on eth3,i can set vlan with id 3 on eth4 (but it has different name), so after that i have to add seperate /ip address for each vlan.
if i use /interface ethernet switch and set there vlan`s, i don't see them in /ip address for settings ip's
if i make vlan3 on eth3, set eth4 and eth5 as slave ports of eth3(=master port), then it seems to doesn't work !?
it looks impossible to make a vlan3 - located on multiple interfaces (eth3,4,5)?
the only way i figured out is to make bridges?
doesn't it affect cpu load and performance?
(e.g., bridge3, joins eth3.vlan3+eth4.vlan3+eth5.vlan3;
bridge4, joins eth4.vlan4+eth5.vlan4)