Tue Aug 09, 2011 5:14 pm
I am battling again, I set up an MPLS Bridge between two routers (Station and AP-Bridge) with Loopback on each. My Wireless and side is running and I can ping the other Side, but I am battling with the ether Side. Have set the following, Loopback Bridge with IP, wlan1 with IP, VPLS interface, LDP Settings and Interface wlan1, Loopback Bridge Route, OSPF Settings redistribute connected and OSPF Network and finally I have brigded the VLPS Interface with the Ether Interface but somehow I am not getting anything there. First I had my IP on the Ether, then on the bridge, but no luck.......Can somebody point me in the right direction please.