Hi


My Isp has released an IPV6 test. I am trying to get my head around this on how to configure my mikrotik (version 5. to work.

I connect using pppoe. Connected directly (without using the router) worked like a charm, no problem

With this configuration on my cisco 871 worked like a charm:

vpdn enable
!
vpdn-group pppoe

# WAN interface
interface FastEthernet4
no ip address
duplex auto
speed auto
pppoe-client dial-pool-number 1 service-name "ipv6test"
!
interface Dialer1
mtu 1492
ip address negotiated
encapsulation ppp
dialer pool 1
ipv6 address dhcp
ipv6 dhcp client pd DH-PREFIX
ppp pap sent-username USER password 7 password
no cdp enable

# LAN interface
interface Vlan1
ip address 192.168.1.1 255.255.255.0
ip tcp adjust-mss 1452
ipv6 address DH-PREFIX 0:0:0:1::/64 eui-64


Can someone help me out with a basic configuration? No matter what i change on my mikrotik i still get a no internet access on my windows 7 pc. And only ipv4 works if i try to ping ipv6.google.com from my pc i get nothing, same if i try a traceroute

I must admit that at this point IPV6 is kind of a mystery for me and in my opinion this protocol is still badly documented.

This is my config for ipv6:
/ipv6 address print detail
0 DL address=fe80::567d:a3fc/64 interface=ISP actual-interface=ISP eui-64=no advertise=no - the pppoe client interface

1 DL address=fe80::20c:42ff:fea4:caf9/64 interface=ether2 actual-interface=ether2 eui-64=no advertise=no - lan interface on which i have the pc connected

/ipv6 nd prefix print detail
Flags: X - disabled, I - invalid, D - dynamic
0 prefix=::1:0:0:0:0/64 interface=ether2 on-link=yes autonomous=yes valid-lifetime=4w2d preferred-lifetime=1w

I manually added 0:0:0:1::/64 in nd prefix.


If someone has some pointers or a full config for a pppoe please let me know

Thank you

This should help:

1) Add an IPv6 address to your LAN interface, where AAAA:BBBB:XXXX is the prefix from your ISP 2) add a default IPv6 route via your ISP Your client PCs will then pick up the advertised prefix on ether2 and address themselves

Hope that helps

Nick.

Routeros doesn't support PPPv6 and prefix delegation (yet).

On the same provider, i managed only to get an ipv6 address using openwrt as a metarouter.
Let's hope this will work in 5.9...

Thanks a lot i will give it a try and see how it goes.