Hi all,

can we use Mikrotik 1100AH as it is L3 switch(i.e. cisco, zyxel,allied, juniper).

need to configure both Vlan trunk & access port in Mikrotik 1100 AH . port 1 to 8 will be the access port with different VLAN and port 10 will be trunk port ..




Regards,
Mak

need to configure both Vlan trunk & access port in Mikrotik 1100 AH . port 1 to 8 will be the access port with different VLAN and port 10 will be trunk port ..

This configuration is not possible as ether1-ether5 and ether6-ether10 belongs to separate switch chips.

However toyu cab make the following configuration for each switch group separately:
http://wiki.mikrotik.com/wiki/Manual:Sw ... heros_8316