Hello,

Recently i used in my network RB 450 for nating my private IP with public IP.. the problem is i m unable to access router xxx.xxx.184.66 from globally while nating is working properly with public IP .
Configuration is below;
Nat
0 chain=srcnat action=src-nat to-addresses=XXX.XXX.184.66 src-address=10.10.10.0/24
1 chain=dstnat action=dst-nat to-addresses=10.10.10.0/24 dst-address=XXX.XXX.184.66

Route
# DST-ADDRESS PREF-SRC GATEWAY DISTANCE
0 A S 0.0.0.0/0 xxx.xxx.184.65 1
1 ADC 10.10.10.0/24 10.10.10.1 ether4 0
2 ADC xxx.xxx.184.64/30 xxx.xxx.184.66 ether2 0
3 ADC 192.168.88.0/24 192.168.88.1 ether2 0

can anyone help me, where i am getting mistake . it will be appreciated.

detail network diagram attached herewith.


Regards,
Mak

Hello,

Recently i used in my network RB 450 for nating my private IP with public IP.. the problem is i m unable to access router xxx.xxx.184.66 from globally while nating is working properly with public IP .
Configuration is below;
Nat
0 chain=srcnat action=src-nat to-addresses=XXX.XXX.184.66 src-address=10.10.10.0/24
1 chain=dstnat action=dst-nat to-addresses=10.10.10.0/24 dst-address=XXX.XXX.184.66

Route
# DST-ADDRESS PREF-SRC GATEWAY DISTANCE
0 A S 0.0.0.0/0 xxx.xxx.184.65 1
1 ADC 10.10.10.0/24 10.10.10.1 ether4 0
2 ADC xxx.xxx.184.64/30 xxx.xxx.184.66 ether2 0
3 ADC 192.168.88.0/24 192.168.88.1 ether2 0

can anyone help me, where i am getting mistake . it will be appreciated.

detail network diagram attached herewith.


Regards,
Mak

Hello! Mak

this problem is not related with NAT, check ==>> IP ==>> Firewall ==> Filter rules

disable any drop rules for chain input.

update us the result.