Dear Guru and Expert
I ‘ve succesfull installation Openwrt (BusyBox v1.16.1 (2010-04-13 10:25:42 EEST) built-in shell (ash)
KAMIKAZE (bleeding edge, r20828) on Mikrotik routerboard 750 GL using 32MB Ram in Metarouter type ( cpu 400 Mhz Ar71xx Atheros AR7242,Ram: 64 MB,and Flash 128 MB)
Using download link: http://wiki.mikrotik.com/wiki/Manual:Metarouter or http://rnd.rajven.net/openwrt/mikrotik/ ... _mikrotik/
Image file = openwrt-mr-mips-rootfs.tgz
System resource:
root@OpenWrt:~# df
Filesystem 1K-blocks Used Available Use% Mounted on
/dev/root 87363 5147 82216 6% /
tmpfs 6976 36 6940 1% /tmp
tmpfs 512 0 512 0% /dev
root@OpenWrt:~# cat /proc/meminfo
MemTotal: 13952 kB
MemFree: 6988 kB
root@OpenWrt:~# top
Mem: 6996K used, 6956K free, 0K shrd, 0K buff, 2508K cached
CPU: 0% usr 0% sys 0% nic 99% idle 0% io 0% irq 0% sirq
Load average: 0.00 0.00 0.00 1/22 1576
Then I need to change to new version barrier_breaker/14.07-rc3/ar71xx/ on Mikrotik RouterBoard RB750GL.
Using download link: http://wiki.openwrt.org/toh/mikrotik/rb750gl and https://downloads.openwrt.org/barrier_b ... /mikrotik/
image file : openwrt-ar71xx-mikrotik-DefaultNoWifi-rootfs.tar.gz
ฺBut It doesn't work properly . It cannot running after import this image to the router.
Question :
1.Why is the extension name .gz instead .tgz? (compare between barrier breaker and kamikaze.
2.This link http://wiki.openwrt.org/toh/mikrotik/rb750gl refer to three files:(1). openwrt-ar71xx-mikrotik-vmlinux-initramfs.elf
(2.)openwrt-ar71xx-mikrotik-vmlinux-lzma.elf
(3.)openwrt-ar71xx-mikrotik-DefaultNoWifi-rootfs.tar.gz
Please advise how to install barrier_breaker on Mikrotik routerboard 750 GL.
Thank you
Banatus S