Anyone ever experience this? Was it resolved?
I have two 260GSPs plugged into a CRS. Both of the 260GSPs are powered using the power supply that they come with directly plugged in. The 1st GSP is powering 3 x BaseBox 2. And it is working fine. The 260GSP is powering 2 x wAP ac and a BaseBox 2. On two of the ports (Port 3 wAP and Port 4 BaseBox) when set to auto I get "current too low" and the devices just continuously cycle. If I set them to "on" they seem to turn on but it only reads 30 to 40mA.... much less than the 100 to 200 the other wAPs and BaseBoxes use.
Thoughts?