Guys we are in trouble......

RB 1000 can't boot. We tried to do netinstall also but it gives us the below error :






RouterBOOT booter 2.12

RouterBoard 1000

CPU frequency: 1333 MHz
Memory size: 512 MB

Press any key within 2 seconds to enter setup..
kernel not found
trying bootp protocol... OK
Got IP address: 10.1.1.3
resolved mac address 00:1E:C9:4E:E9:15
transfer started ......................... transfer ok, time=1.14s
setting up elf image... OK
jumping to kernel code
Oops: Kernel access of bad area, sig: 11 [#1]
RB1000
NIP: 8011b800 LR: 8011b7e8 CTR: 00000001
REGS: 9f81bd20 TRAP: 0300 Not tainted (2.6.27.13)
MSR: 00029000 <EE,ME> CR: 22000082 XER: 20000000
DEAR: 00000000, ESR: 00800000
TASK = 9f81c000[1] 'swapper' THREAD: 9f81a000
GPR00: 00100100 9f81bdd0 9f81c000 8029e898 40000000 ffffffff 802b0000 802b1758
GPR08: 00000001 00200200 00000000 00000000 42000048 00000001 0071a2fc 00000040
GPR16: 00000000 ffff44ca 00000001 000000ff fffff9ab 8d9d4f63 ffff44d5 9f83ceac
GPR24: 9f8b0e10 9f83ceac 9f8b0e00 00100100 00200200 9f83ceb4 8029e898 9f83ceac
NIP [8011b800] hwrng_unregister+0x3c/0x104
LR [8011b7e8] hwrng_unregister+0x24/0x104
Call Trace:
[9f81bdd0] [ffffffed] 0xffffffed (unreliable)
[9f81bdf0] [801f4a14] talitos_remove+0x94/0x680
[9f81be20] [801649ec] talitos_probe+0x630/0x648
[9f81be70] [80165a48] of_platform_device_probe+0x5c/0x380
[9f81be90] [80125944] driver_probe_device+0xe8/0x18c
[9f81beb0] [80125a38] __driver_attach+0x50/0x84
[9f81bed0] [80124eac] bus_for_each_dev+0x58/0x98
[9f81bf00] [80125744] driver_attach+0x24/0x34
[9f81bf10] [801253b4] bus_add_driver+0xb4/0x218
[9f81bf30] [80125ca4] driver_register+0xa8/0x13c
[9f81bf50] [8016591c] of_register_driver+0x40/0x50
[9f81bf60] [8027fe38] talitos_init+0x20/0x30
[9f81bf70] [80001780] do_one_initcall+0x58/0x174
[9f81bfe0] [8026c170] kernel_init+0x7c/0xe4
[9f81bff0] [8000c418] kernel_thread+0x44/0x60
Instruction dump:
bfa10014 3bc9e898 7c7d1b78 7fc3f378 90010024 480d3dd9 815d001c 3c000010
817d0018 3d200020 60000100 61290200 <916a0000> 3fe0802c 914b0004 901d0018
---[ end trace 569d0fa5cb00e135 ]---
Kernel panic - not syncing: Attempted to kill init!
Rebooting in 180 seconds..



Please help us regarding this issue !!

The firmware is older than the latest one. See http://www.routerboard.com/files/rb-2.1 ... 8-2.18.fwf You may wish to consider upgrading it.

Have you installed memory or a CF card on the board? Remove/swap it temporarily.

Have you tried to see what happens when you load the primary boot image (press and hold reset switch on power up) rather than the secondary one which is normally used.

If all else fails, suggest you raise a support call with support@mikrotik.com!

Let us know what you find out.

Ron.

mistake in that link, correct is:
http://www.routerboard.com/files/rb-2.1 ... 8-2.18.fwf

Thanks Normis.
I got the link direct from the routerboard website. I did notice that the text said 2.18, but the url pointed to 2.19. Didn't think to actually test the link to see if it was correct. Just assumed it was!

Ron