Page 1 of 1

Problem with QoS and winbox

Posted: Mon Jun 27, 2011 2:13 pm
by Yukado
Hi,

I want to configure QoS rules that appear in this site:

http://wiki.mikrotik.com/wiki/Traffic_P ... lemetation

But I have a problem. When I enable the bridge, I can't connect to winbox.

I have few experience using Mikrotik.

I hope you can help me

Thanks for your time.

Re: Problem with QoS and winbox

Posted: Mon Jun 27, 2011 10:51 pm
by Egate
Give bridge the ip, also possible to access router board with winbox.

Re: Problem with QoS and winbox

Posted: Wed Jun 29, 2011 1:55 pm
by Yukado
I can't access using winbox.

How can I get the bridge's ip?

Thanks for your time.

Re: Problem with QoS and winbox

Posted: Wed Jun 29, 2011 2:05 pm
by Caci99
What type of routerboard are you using? If it has a serial port you can connect to it
through this port.
Have you tried to connect using mac-address with winbox, instead of IP address?

Re: Problem with QoS and winbox

Posted: Wed Jun 29, 2011 3:00 pm
by Egate
Do as Casi say, was also talking about mac in winbox. To give bridge the ip, you just select the bridge as the interlace when you create ip.

Re: Problem with QoS and winbox

Posted: Fri Jul 01, 2011 1:07 pm
by Yukado
I am using a PC like Mikrotik Router. I am using Ethernet port to connect.

I have seen that the ip address change to another network when I enable the bridge. For example, it changed from 192.168.1.xx to 192.168.0.xx.

Maybe you can see the problem now.

Thanks for your time.

Re: Problem with QoS and winbox

Posted: Fri Jul 01, 2011 7:56 pm
by Egate
Pc, also has a serial port, will work with telnet, read manual on howto. You can use mac instead if ip to connect onto mikrotik with winbox, on Ethernet port.
Assign ip to bridge, normally bridge take Ethernet port ip automatic, but better to assign. Only assign bridge the ip, not any of the ports using bridge, like your Ethernet port.

Re: Problem with QoS and winbox

Posted: Wed Jul 06, 2011 12:50 pm
by Yukado
How can I assign the ip to the bridge?

Re: Problem with QoS and winbox

Posted: Wed Jul 06, 2011 1:37 pm
by Caci99
From winbox, just double click on the address and assign the interface
on the drop down menu interface in that window.
From terminal:
/ip address
print
after command print you will see the ip address you want to assign on the bridge interface
and let's suppose that it has a number assigned "0", then:
/ip address
set 0 interface=bridge1