802.11n throughput problem
Posted: Mon Feb 06, 2012 9:48 am
I'm testing RB433GL with Compex(WLM200N5-23, 2X2 mimo) and UNEX(DNMA-H5 3X3 mimo).
My PCs have Gigabit ethernet port.
I set
- AP-Bridge mode
- 5GHz-A/N
- 20/40MHz HT Ablove
- 5200MHz
- HT Tx chain: Chain0, Chain1
- HT Rx chain: Chain0, Chain1
- HT Guard Interval: any
- WDS mode: dynamic mesh
- other things are all factory default parameter.
below capture, you can see 20/40MHz as I set. But below capture, scanned result is only 20MHz. Throughput test is only around 20Mbps. I wish more then 200Mbps at indoor.
I bet, in our test room, there is no 5GHz device and other 5GHz wireless device is more then 200Mbps.
I wish to get answer any of you.
And strongly wish to get answer from mikrotik.
My PCs have Gigabit ethernet port.
I set
- AP-Bridge mode
- 5GHz-A/N
- 20/40MHz HT Ablove
- 5200MHz
- HT Tx chain: Chain0, Chain1
- HT Rx chain: Chain0, Chain1
- HT Guard Interval: any
- WDS mode: dynamic mesh
- other things are all factory default parameter.
below capture, you can see 20/40MHz as I set. But below capture, scanned result is only 20MHz. Throughput test is only around 20Mbps. I wish more then 200Mbps at indoor.
I bet, in our test room, there is no 5GHz device and other 5GHz wireless device is more then 200Mbps.
I wish to get answer any of you.
And strongly wish to get answer from mikrotik.