Hello,

In the command line I can see the OSPF neighbor's adjacency time:

[me@router] /routing ospf neighbor> print
0 instance=default router-id=1.2.3.4 address=1.2.3.4 interface=IF1 priority=1 dr-address=0.0.0.0 backup-dr-address=0.0.0.0
state="Full" state-changes=16 ls-retransmits=0 ls-requests=0 db-summaries=0 adjacency=18h54m23s

But I would really like to get this data via SNMP. Is that possible?

Thanks!

- Jim Wiggins
- Contractor to inveneo.org

Most submenus that have information accessible via an SNMP OID will reveal the OIDs to you with the 'print oid' command (for example, '/interface print oid' will show you the OIDs for each interface). This command does not appear to be available under any of the '/routing' submenus, so I have my doubts that there is an OID that exists for this information. (Also, if I try walking the OID on a MikroTik that Cisco uses for OSPF neighbor table information (.1.3.6.1.2.1.14.10), I get back nothing.)

If you are handy with scripting at all, you could surely devise a way to get the information you want programmatically using the RouterOS API.

-- Nathan