Community discussions

MikroTik App
 
januszzz
Member Candidate
Member Candidate
Topic Author
Posts: 105
Joined: Wed Oct 07, 2009 9:17 pm

Can't connect to 3G network

Wed Mar 28, 2012 10:06 am

Hello, I'm trying to get Dell 5530 modem to connect to 3G. Modem works, I can see info, PIN is properly passed, but this just don't connect:
[admin@MikroTik] >                 
echo: async,debug usb2:0: sent ATH
echo: async,debug usb2:0: rcvd OK
[admin@MikroTik] > 
echo: async,debug usb2:0: sent AT+CGDCONT=1,"IP","internet"
echo: async,debug usb2:0: rcvd OK
echo: async,debug usb2:0: sent ATDT*99***1#
[admin@MikroTik] > 
  (45 messages discarded)
echo: async,ppp,debug ppp-out1: CCP lowerdown
echo: async,ppp,debug ppp-out1: BCP lowerdown
echo: async,ppp,debug ppp-out1: BCP down event in starting state
echo: async,ppp,debug ppp-out1: IPCP lowerdown
echo: async,ppp,debug ppp-out1: IPV6CP lowerdown
echo: async,ppp,debug ppp-out1: IPV6CP down event in starting state
echo: async,ppp,debug ppp-out1: MPLSCP lowerdown
echo: async,ppp,debug ppp-out1: MPLSCP down event in starting state
echo: async,ppp,debug,packet  ppp-out1: sent LCP TermAck id=0x1
echo: async,ppp,debug ppp-out1: LCP lowerdown
echo: async,ppp,debug ppp-out1: LCP lowerdown
echo: async,ppp,debug ppp-out1: LCP down event in starting state
[admin@MikroTik] > 
echo: async,debug usb2:0: sent ATH
echo: async,debug usb2:0: modem hung up
echo: async,ppp,debug ppp-out1: LCP lowerdown
echo: async,ppp,debug ppp-out1: LCP down event in starting state
      data-channel=0 info-channel=0 apn="internet" pin="" user="orange" 
      password="orange" profile=default phone="" dial-command="ATDT" 
      modem-init="AT+CFUN=1" null-modem=no dial-on-demand=no 
      add-default-route=yes use-peer-dns=yes keepalive-timeout=30 
      allow=pap,chap,mschap1,mschap2 



 interface ppp-client info  
number: 0
             status: ready
         pin-status: no password required
      functionality: full
       manufacturer: Dell
              model: D5530
           revision: R1B/1
      serial-number: n/a
   current-operator: ERROR
  access-technology: ERROR
     signal-strengh: n/a
   frame-error-rate: n/a
How to make it connect? How to debug further (see those discarded messages)?

Thanks a lot.

Who is online

Users browsing this forum: Babujnik, Bing [Bot], stanisljevic and 98 guests