Simple QUEUE
RouterOS general discussion

2 posts   •   Page 1 of 1
shdwmstff
just joined
 
Posts: 23
Joined: Wed May 30, 2012 12:00 am

Simple QUEUE

by shdwmstff » Tue Aug 14, 2012 4:33 pm

Using simple queue to limit bandwidth on an interface, And user is complaining that they can only receive total bandwidth in one direction at a time. this is the config.

When doing a transfer currently using almost 10mb upload for an hour.. they were unable to pull more than 3 megs down at the same time. (is there something wrong in the config I'm using?)

admin@MikroTik] /queue simple> print
Flags: X - disabled, I - invalid, D - dynamic
0 name="Cust1" target-addresses="" interface=ether2 parent=none
packet-marks="" direction=both priority=8
queue=default-small/default-small limit-at=12M/12M max-limit=12M/12M
burst-limit=0/0 burst-threshold=0/0 burst-time=0s/0s
total-queue=default-small


Question the whats difference between "Max-limit" and "Limit-at" options?

User avatar
greencomputing
Frequent Visitor
Frequent Visitor
 
Posts: 95
Joined: Wed Jun 23, 2010 1:12 pm
Location: Italy

Re: Simple QUEUE

by greencomputing » Wed Aug 15, 2012 1:50 am

Hi sir
to have simple queue working in a deterministic way as expected, please define both properties target-addresses and interface.

Doing so you will observe a queue behaviour as expected.

As reported by wiki http://wiki.mikrotik.com/wiki/Manual:Queue:
Be careful to configure both of these options for the same queue - in case they will point to opposite directions queue will not work.

If neither value of target-addresses nor of interface is specified, the queue will not be able to make difference between upload and download, and will limit all traffic twice.
If answer was helpful to you why to not plan to... give me karma :)
greencomputing

--------------------
MTCNA / MTCRE certified Senior Mikrotik Consultant

2 posts   •   Page 1 of 1

Who is online

Users browsing this forum: Bing [Bot], xibai99 and 27 guests

It is currently Sun Nov 23, 2014 11:22 am