Its not DMA related issue.
rahulmkhj wrote:Dear folks,
I'm going through a weird problem. I'm using RB1100AHx2 with hotspot setup. And using external radius server for AAA. Everything works fine with 2-3 users authenticated. But, as more users login. The latency goes very high. for example, 126.96.36.199 goes to 600-700ms, while in general it goes till ~40ms and also from within the router latency is normal. And this issue is not just with hotspot interface, but all of the 13 interfaces available on router. When I tried testing speed from some other non-hotspot interface, I get only 2~3Mbps while total available bw on wan is 40Mbps.
I'm using ROS version 5.20.
Its just a radius server (probably residing on your lan/same subnet). There must be some configuration issue or network design fault at your end. Try following.
- First thing First. Upgrade your ROS to latest release that is 5.25 or preferably 6.x Hopefully it will solve your issue related to queues,
in v6, *) fixed queues - router could become unresponsive when configuring queues;
- Do strict monitoring via using RESOURCES , also Goto PROFILES and see what section is eating the CPU- Make sure there is no virus flooding floating on your network. As HOTSPOT uses default gateway of your mikrotik router, then you must monitor users traffic for junk traffic.
- Reset to factory default, and re configure all your settings.
- Its common that some times troubleshooting takes longer time/downtime then rebuilding new one, specifically in Mikroitk where configuration can be done just in few minutes.