Hi,
I am trying to run OpenWrt on RB411GL (there is no serial) but after load of image via TFTP the RB just beeps and it is not responding (over ethernet to be specific)
So if there is anyone who has accomplished that - running OpenWrt on RB411GL - I'd like to ask couple of questions:
(I followed these instructions - https://wiki.openwrt.org/toh/mikrotik/rb411 and used tftpd64 on 64bit W10)
- can I use https://downloads.openwrt.org/barrier_b ... tramfs.elf on RB411GL
- is there any preset ethernet setting in https://downloads.openwrt.org/barrier_b ... tramfs.elf
(why am I asking? in the guide mentioned above there is a line saying "now back to the serial console: ifconfig eth0 192.168.1.250 up" so I am assuming the eth0 is not up by default)
- if not, how to set ethernet interface without serial (RB411GL does not have one)
Thanks a lot!