Hi,
RouterBoard 230,(With mikrotik Version 2.8 on it).I receive the board as a gift from friend of mine in Germany,board is used so I don't have idea how it is configured or is it working at all.
I see there is PCMCI wireless card in slot,64mb of ram (PC133),
compact flash card - 64mb PQI, all other slots are free.
Using a Cisco cable :
http://cgi.ebay.co.uk/NEW-CISCO-72-3383 ... 27acabc86e
with Rj45 to Db9 connector on the other end :
http://www.google.com/products/catalog? ... BoQ8gIwBA#
For power supply i am using adapter with 20v (for my lap-top)
When router boots regularly all leds are lighting and the beep sound is there.After only led6 is on.
Not getting the output on serial console, trying puty and win hiperterm but nothing.
then i tried few times resetting the JP1 jumper ( all leds lighted - seems ok ).
Check the jp5 1-2 pins are connected for for supply on jack 20-56v.
I noticed that when all leds are lighting while booting,1 and 3 are green,2 and 4 red (if matters)
Wireless lan card have one led and it's off, after powering on processor is heating - seems the board is working but not cooperating .
Console settings are 9600 baud 8 bit 1 stop bit no parity.There is no output on console - blank,just like nothing is connected!
Can anybody help please? i can return the board if it is not working
PS.
Also check the CMOS battery measuring only 0,3v ! (0,5v when is on board powered on!).Is this causing the problem???
I will replace the battery tomorrow and post again!
Best regards,
Cybercom