RB112 is resetting conifguration after power off

jalokim · Mon Feb 15, 2010 11:20 am

Hi,

RouterBoard 112

CPU frequency: 175 MHz
  Memory size:  16 MB

Boot configuration reset, applying defaults
writing settings to flash... OK

Press any key within 2 seconds to enter setup..
loading kernel from nand... OK
setting up elf image... OK
jumping to kernel code
Starting...
Resetting system configuration...
Starting services...

I was tring to format nand and netinstall all from begening. Mem test show no probleblems.

Any ideas?

Mon Feb 15, 2010 11:36 am

make sure you have not shorted any jumpers on the board. if some wire is touching the reset jumper, this will happen

jalokim · Mon Feb 15, 2010 12:28 pm

make sure you have not shorted any jumpers on the board. if some wire is touching the reset jumper, this will happen

I've taken from board pin reset and dip switch reset. So there is no way to short this.

jalokim · Tue Feb 16, 2010 6:43 pm

Nice to have support .... :/

Wed Feb 17, 2010 8:48 am

this is a user based forum, not a support system.

check if you don't have any damage on the PCB board, maybe there is a scratch or some solder traces that are causing the resets. Like I said, the jumper is the only thing that can reset it. Either that, or some connection leading to it.

RB112 is resetting conifguration after power off

RB112 is resetting conifguration after power off

Re: RB112 is resetting conifguration after power off

Re: RB112 is resetting conifguration after power off

Re: RB112 is resetting conifguration after power off

Re: RB112 is resetting conifguration after power off

Who is online