I have a 5.8 mikrotik radio and it has been compromised. i have been screened out through nat plesse help me out. how can i get into my radio back.

i still know the user name and password. its just that i cant see it in winbox.

Any one has an answer to this.

i will be most garteful.

Use the console port.

FEWI, THANKS BUT I AM STILL HAVING A PROBLEM WITH THE RADIO,

I CANT CONNECT THRU CONSOLE.

I DONT KNOW HOW TO CONNECT WITH CONSOLE CABLE.PLEASE HELP ME OUT.

I CONNECTED THE SERIAL END TO THE BOARD AND THE RJ45 END TO MY LAPTOP BUT NO SIGNAL, I REVERSED IT STILL NO SIGNAL. PLEASE I NEED TO DO THIS AS SOON AS POSSIBLE. I AM REALLY ATUCK HERE.

THE BOARD IS A 600 SERIES.
BASICALLY JUST TEACH ME HOW TO ACCESS IT THRU CONSOLE.

AM I STILL GOING TO USE THE NORMAL ADMIN PASSWORD TO LOGHIN?

I AM SO USED TO WINBOX AND USERMAN. I HAVE NOT USED THE CONSOLE BEFORE.

WHAT TYPE OF CONSOLE? - SERIAL TO SERIAL OR RJ45 TORJ45(ROLL OVER)

THANKS IN ANTICIPATION.
HOPE TO READ FROM YOU SOON.

... or just connect using a different piece of equipment, connect with Radio, and use MAC Telnet, seeing as you know the admin password.

If you forgot the admin password, post me the board or a backup and i'll tell you.

i have tried console and telnet but it would not just respond

the radio is cooected to a switch alongside other radios but only this radio will not ping.

please house, i want to reset the radio, please help me out.

how can i reset the radio or rather restore it back to a certain configuration
is there any thing physical reset bitton on the radio that i can use to reset the radio? cos there is a toggle switch beside the led. how can i use this to reset it.

IF I CONNECT THRU ANOTHER RADIO,

I PINGED THE INTERFACE IT REPLIED BUT WITH "net prohibited"

I TRIED TELNET AND MAC TELNET, IT SAYS CONNECTION REFUSED.

WHAT CAN I DO TO RESET IT.

I ALSO NEED THE CONFIGURATION SO I CAN SET IT UP AGAIN.

I HAVE 4 CARDS ON IT BUT I AM USING 3 ANTENNAS SO I WANT THE LAST ONE TO BRIDGE TO ONE OF THE CARD.

THANKS ALOT, I AM REALLY COUNTING ON YOU.

Use http://wiki.mikrotik.com/wiki/Manual:Netinstall NetInstall to rest to factory defaults.

Stop USING ALL CAPS and shouting.

Thanks House, i have been able to reset my device. God bless averyone