Hi all,

I'm working with 2.4 ghz. 2 AP. RB-433UAH one to 12 mts, the other one 18 mts. in the same tower. since a while my AP are dropping all clients.

21:21:10 wireless,info InterClick: data from unknown device 30:7C:30:2B:2C:64, s
ent deauth
21:21:21 wireless,debug InterClick: 00:23:7A:CD:07:72 attempts to associate
21:21:21 wireless,debug InterClick: 00:23:7A:CD:07:72 in local ACL, accept
21:21:21 wireless,info 00:23:7A:CD:07:72@InterClick: connected
21:22:03 wireless,info InterClick: data from unknown device 30:7C:30:2B:2C:64, s
ent deauth
21:22:06 wireless,info 00:23:CD:F8:96:0F@InterClick: disconnected, extensive dat
a loss
21:22:10 wireless,info 00:23:7A:CD:07:72@InterClick: disconnected, extensive dat
a loss
21:22:13 wireless,debug InterClick: 00:23:7A:CD:07:72 attempts to associate
21:22:13 wireless,debug InterClick: 00:23:7A:CD:07:72 in local ACL, accept
21:22:13 wireless,info 00:23:7A:CD:07:72@InterClick: connected
21:22:17 wireless,info 00:23:7A:CD:07:72@InterClick: disconnected, extensive dat
a loss
21:22:21 wireless,info InterClick: data from unknown device 30:7C:30:2B:2C:64, s
ent deauth
21:22:31 wireless,info InterClick: data from unknown device 30:7C:30:2B:2C:64, s
ent deauth
21:22:41 wireless,info InterClick: data from unknown device 30:7C:30:2B:2C:64, s
ent deauth
21:22:51 wireless,info InterClick: data from unknown device 30:7C:30:2B:2C:64, s
ent deauth
21:22:58 wireless,info InterClick: data from unknown device 30:7C:30:2B:2C:64, s
ent deauth
21:23:18 wireless,debug InterClick: 00:23:7A:CD:07:72 attempts to associate
21:23:18 wireless,debug InterClick: 00:23:7A:CD:07:72 in local ACL, accept
21:23:18 wireless,info 00:23:7A:CD:07:72@InterClick: connected


any help would be appreciate.

Hello

Any chance you would be able to show signal levels?
int wire reg pr

int wire monitor 0 (or whatever interface you have it connected too)
then check your noise floor

if its the only link then it's going to show your SNR
e.g.
signal-strength: -44dBm
tx-signal-strength: -36dBm
noise-floor: -98dBm
signal-to-noise: 54dB
tx-ccq: 100%
rx-ccq: 100%
p-throughput: 38878
current-ack-timeout: 28
current-distance: 28

If you are getting a drop out because of extensive data loss i would say its either a signal issue
or your ack-timeout is too low/high
e.g.
int wire set 0 ack-timeout=60

Hellson