Guys,
could someone help me configure my RB493AH, I'm new to this router
I want to change the IP address of my RB493Ah to 10.10.10.254 & netmask 255.255.254.0 and use eth1 as WAN and enable NAT but disable DHCP. please help me configure my router base on the picture above.
and last, i should be able to access RB493AH from my Main tower. My dsl modem is auto-connect to my ISP, could someone help me about this config.
even 10.10.10.254 is not pingable from internal network.
Any help will be greatly appreciated.
Thanks