Community discussions

MikroTik App
 
darifaj
just joined
Topic Author
Posts: 9
Joined: Mon Nov 22, 2010 4:28 pm

RB 1200 Crash

Fri Jul 08, 2011 5:34 pm

Hi,

I just bought a brand new RB1200 router , created a simple config (ROS 5.2) and after I issued a command to restart it never comes back online again. Tried mac-telnet to access it but not successful. The indication is it is not booting at all any more.

Does anyone have information or experience like this with this kind of router. I'm looking on ways to factory default but no manual in rb sites is available.
 
fewi
Forum Guru
Forum Guru
Posts: 7717
Joined: Tue Aug 11, 2009 3:19 am

Re: RB 1200 Crash

Fri Jul 08, 2011 5:40 pm

Connect a serial cable (115200 baud) and see what the console says.
 
darifaj
just joined
Topic Author
Posts: 9
Joined: Mon Nov 22, 2010 4:28 pm

Re: RB 1200 Crash

Sat Jul 09, 2011 8:20 pm

I have no output at all from the console port. Any other idea.
 
fewi
Forum Guru
Forum Guru
Posts: 7717
Joined: Tue Aug 11, 2009 3:19 am

Re: RB 1200 Crash

Sat Jul 09, 2011 9:05 pm

If there's nothing at all on the console then it's dead. Try to RMA it through the vendor you bought it from.
 
webguyz
Frequent Visitor
Frequent Visitor
Posts: 52
Joined: Tue May 29, 2007 7:40 pm

Re: RB 1200 Crash

Sun Jul 10, 2011 5:25 pm

Have you tried unplugging the power and waiting 30 seconds. On our RB1200 if you unplug the power and don't wait a few extra seconds it won't come up. Count to 30 before plugging it back in. :?
 
darifaj
just joined
Topic Author
Posts: 9
Joined: Mon Nov 22, 2010 4:28 pm

Re: RB 1200 Crash

Wed Jul 13, 2011 1:48 pm

This is sorted out, according to support this is a bug. See below.

Hello,

Thank you for reporting this problem. It is detected and will be fixed in
next RouterOS releases.

Regards,





> Hi support,
>
> I've bought a brand new RB1200 router and configured it in a way where ports
> eth1,eth2 are routing traffic and disabled all other ports. All was working
> fine but a single system reboot command makes the router unusable any more
> as it passes no more traffic after this. The only way to make it work is to
> connect via serial console and enable all disabled ports (which were not
> used anyway) which is not a correct behavior.
>
> I've attached the supout file for your reference.
>
> BR,

Who is online

Users browsing this forum: infabo and 24 guests