Page 1 of 1

can't reset rb1200 using reset button

Posted: Mon Aug 01, 2011 11:37 am
by temuri426
hello
we've bought three rb 1200 and i'm unable to reset username and passwords from reset button. i pressed on int while power cycling , but no results..

i knew about other solution opening the box hold screwdriver in reset hole, but i dont need eny time to open almost 15 screws,,

is there any simple solution using reset button?


thanks

Re: can't reset rb1200 using reset button

Posted: Mon Aug 01, 2011 11:40 am
by normis
sorry but the button on RB1200 only loads the primary boot loader, to do reset, you must open the case. this is explained in the guide:

http://routerboard.com/pricelist/downlo ... ile_id=308

Re: can't reset rb1200 using reset button

Posted: Mon Aug 01, 2011 3:00 pm
by temuri426
thanks normis

But if i can reset all configuration using reset button in rb750, so why it is not posible to do the same in rb1200.. ?

Re: can't reset rb1200 using reset button

Posted: Mon Aug 01, 2011 3:10 pm
by normis
the behaviors are different in our rackmount/professional series and in our plastic case low cost series. we will move to the more convenient system in the future.

Re: can't reset rb1200 using reset button

Posted: Mon Aug 01, 2011 3:15 pm
by temuri426
thanks..