Can it be wall mounted?

It has a DIN rail mount included. So if you can wall-mount a DIN rail, then yes

But it is not directly wall mount without the rail.

Sent from my SCH-I545 using Tapatalk

No, without any extra things, it is not meant for direct wall mounting

Hi efaden,

For a few Euro/Dollars you can combine the following 2 pieces -

Wall mounting side - http://www.rfelements.com/en/products/b ... bracket-s/
BaseBox side - http://www.rfelements.com/en/products/b ... acket-912/

Rgds,
Mark.

Hi efaden,

For a few Euro/Dollars you can combine the following 2 pieces -

Wall mounting side - http://www.rfelements.com/en/products/b ... bracket-s/
BaseBox side - http://www.rfelements.com/en/products/b ... acket-912/

Rgds,
Mark.

Anyone sell those in the US?

Hi efaden,

Only takes some effort - http://www.rfelements.com/en/where-to-buy/americas/usa/

Rgds,
Mark

Hi efaden,

Only takes some effort - http://www.rfelements.com/en/where-to-buy/americas/usa/

Rgds,
Mark

Thanks

Hello,
I am writing to this old topic because it is the most related to my question.

Is there available any mechanical drawing which shows the dimensions of the mounting plate? I would like to have the distances between the 4 screws on the back of the BaseBox2 in order to construct a new mounting base.

I have already a BaseBox2 (RB912UAG-2HPnD-OUT) which is installed but not easily accessible in order to measure them (too high and over powerlines). It is going to be relocated but i want to construct a new screw plate beforehand.

Thank you in advance