I have one RB 750, it was running ok no problem but after resetting it I can't log in and even the Ethernet ports are not blinking(when connected with any PC or switch). I have reset it as it is said in the Routerboard website. The Ethernet port blinks for few seconds but after that no sign of activity. Any idea?

Nobody has any idea? BTW ethernet ports blinks for few seconds after resetting the board after that no activity and pc lan show only send bytes no received byte. anybody haven't faced that kindda problem?

Have you nothing from light that burning?

Try netinstall procedure
Make sure that firewall is disabled on PC

http://www.wirelessinfo.be/index.php/mi ... etinstalle

Nobody has any idea? BTW ethernet ports blinks for few seconds after resetting the board after that no activity and pc lan show only send bytes no received byte. anybody haven't faced that kindda problem?

did you connected to ether1 (1st port)?

Thanks a lot guys, specially plisken the netinstall was the key. After netinstall the router is ok, relieved. Alhamdulillah.

Your welcome great the routerboard is working now
Goodluck
If you want give me karma please thanks

Your welcome great the routerboard is working now
Goodluck
If you want give me karma please thanks

I have a RB750 with os v5.25 try to upgrade to 6.18. using winbox.
after reset there routerborad has gone! the pwr LED is on. the act led blink 2 time after power on and then goes off the Ethernet port 1 led is like act led. I am connecting rb750 to my laptop throw a direct cable between Ethernet poet 1 of rb750 to my Ethernet connector of laptop.
when running netinstall and press netbooting bottom and enter the ip address no item added for my routerborad in router/driver division of software!so i can not go further.
what can i do?
please help

First try to connect the routerboard with ether 2-5

If don't lucky follow the correct netinstall procedure
http://www.wirelessinfo.be/index.php/mi ... etinstalle

First try to connect the routerboard with ether 2-5

If don't lucky follow the correct netinstall procedure
http://www.wirelessinfo.be/index.php/mi ... etinstalle

connecting to 2-5 port are not different with connection to port 1. when the cable connected to each 8 port all leds keep off and no connection possible via software(winbox or web-base)

in netinstall procedure in fifth picture after drives there is a routerborad that i ask to select(named RB751G...) but when i try the same procedure my system can not find any routerborad in this (fifth picture) step!!!