i have big problem.
i replaced my OmniTIK with NetMetal 5 + 13DB omni antenna .
same configuration, same place ,same clients but issue is
when CPE receive from OmniTIK the signal strengths more than 40db
and same client when receiving from netmetal the signal strengths less than 25db!!!
that's my ap config
Code: Select all
/interface wireless
set [ find default-name=wlan1 ] ampdu-priorities=0,1,2,3,4,5,6,7 \
default-forwarding=no disabled=no disconnect-timeout=15s frequency=5280 \
hw-protection-mode=rts-cts hw-retries=15 mac-address=00:xx:xx:xx:xx:xx \
mode=ap-bridge multicast-helper=full nv2-cell-radius=70 on-fail-retry-time=\
1s proprietary-extensions=pre-2.9.25 radio-name=smartnet5g rate-set=\
configured rx-chains=0,1 ssid=smartnet supported-rates-a/g=\
6Mbps,9Mbps,12Mbps,18Mbps,24Mbps tx-chains=0,1 wds-default-bridge=\
bridge-local wds-ignore-ssid=yes wds-mode=static wireless-protocol=nstreme \
wmm-support=enabled
/interface wireless nstreme
set wlan1 disable-csma=yes enable-nstreme=yes framer-limit=4000 framer-policy=\
best-fit
and my CPE config
Code: Select all
/interface wireless
set [ find default-name=wlan1 ] disabled=no disconnect-timeout=15s frequency=\
auto hw-retries=15 mode=station-wds name=wlan1-gateway \
proprietary-extensions=pre-2.9.25 radio-name=hzaz rate-set=configured ssid=\
smartnet supported-rates-a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps \
wds-default-bridge=bridge1 wds-ignore-ssid=yes wds-mode=static \
wireless-protocol=nstreme wmm-support=enabled
/interface wireless nstreme
set wlan1-gateway enable-nstreme=yes
/interface wireless security-profiles
please any advice????
