Hello,

i hope everyone is fine here and enjoying mikrotik filters and problems . i have one problem also, yesterday i bought one Mikrotik QRT2 Wireless Routerboard and i make it as Access Point ( Ap Bridge Mode), and i have done in many other mikrotik wireless devices and they works very fine but in this device i face an problem.. i have one pppoe server in x86 system and i am managing my all pppoe clients from x86 and i make this QRT2 as access point so if any user want to connect he/she have to use PPPoE dialer, but my user can not communicate with my x86 Mikrotik PPPoE Server from QRT2 Wireless .. i tired in other mikrotik devices but in this devices i can not . i need expert guide..


Here is Setting of QRT2

wireless mode in ap bridge (access point)
and then i have created a bridge between eth1 and wlan1

bridge1 .. and ports are wlan1 and eth1..



Sorry for my bad english

Can you post an export?

What about ROS/Firmware versions?

Do you "see" the PPPoE server if you do a PPPoE Scan from the QRT2?

Do clients connect with regular devices (phones, laptops, etc) or using CPEs? If so, post an export...