I have WDS bridge made from SXT Lite2 in bridge mode and GrooveA 52HPn in station WDS mode. They both are using NV2 protocol and dynamic WDS. When I turn on wireless interface, station successfully connects and data transfering correctly. But only first 15 seconds. Does someone know in what side I need to dig to discover a reason of that behavior? Firmware on both routers is latest, 6.33.3.
In client mode, SXT Lite2 works proper but network architecture doesn't allow me to set up GrooveA into bridge mode and SXT Lite2 into station WDS mode.

Good Day,

After 15s does the data transmission stop or does the sxt shut off and reboot?

Is the devices still connected wireless or does it disconnect?

And can you ping the other side after 15s?

Good Day,

After 15s does the data transmission stop or does the sxt shut off and reboot?

Is the devices still connected wireless or does it disconnect?

And can you ping the other side after 15s?

No, SXT hangs up and I cannot ping or have connections throw birdge. I need to reboot router by power and then it works again. Only first 15 seconds. If I'm enough fast to disable WLAN, router works normally (but without WLAN).

Have you checked the nv2 key ?

Factory reset the side that has the issue, I had an identical issue after upgrading a pair of netmetals, If either the wlan or the lan interface was up just by itself everything was fine, but as soon as both of them came up I would loose connectivity to the device and everything through it even though it stayed registered to the AP. I ultimately had crew on the ground factory reset it and redo the config and it worked.