Hi, I need to change some property of the wireless interface on CAP which is controlled by CAPsMAN. For example, hw-retries, wireless protocol, datarate...properties that are not available to configure through CAPsMAN.

I can disable CAP protocol on CAP router, change the necessary property values and then enable CAP protocol. Should these changes be applied or not...?

Any suggestion?

mIRO

nv2 is not supported in Capsman

I will generalize my question: How to change some option (property) for CAP wireless interface that isn't supported by CAPsMAN ?

Thanks

Related to this, I would like to be able to specify (enable or disable) specific rates on wireless interfaces managed by CAPsMAN.

I will generalize my question: How to change some option (property) for CAP wireless interface that isn't supported by CAPsMAN ?
Thanks

It's like an elephant and a refrigerator. You can do it in three steps:
- disable cap
- manualy set proper option
- enable cap mode

Related to this, I would like to be able to specify (enable or disable) specific rates on wireless interfaces managed by CAPsMAN.

Possible with new wir-rep package.

Winbox -> Wireless -> CAP -> remove chek ENABLE