I'm trying to setup a new hAP ax2 running 7.14.1 in a 'station' mode in the office where wifi is the default connection method.
I've completely deleted the configuration on the device and configured a bare minimum for the connection to be established, but the router keeps jumping between 'Scanning' and 'Connecting' modes and not establishing a connection.
Here is the config:
Code: Select all
# software id = DSQQ-JU0R
#
# model = C52iG-5HaxD2HaxD
/interface wifi
set [ find default-name=wifi1 ] configuration.country=\
Netherlands .mode=station .ssid=WIFI-PUB security.authentication-types=\
wpa2-psk
/system logging
add topics=wireless,debug
/system note
set show-at-login=no
So far I've tried to connect to a couple of other wireless networks/SSIDs and it worked just fine - one was my phone acting as a modem, the other was my personal hotspot. I've connected a cheap Keenetic device in Wireless ISP mode to this particular SSID to make sure there are no restrictions for wireless routers as stations and it worked fine. I've mimicked the SSID and passphrase on the phone to make sure there are no 'special characters' issues or something. I've even changed the MAC on the ax2 wireless interface to my iPhone's MAC address just in case. Changed it back once it did not help.
Wireless debug logging does not catch the connection attempts ax2 is making, no information at all. I'm stuck for a full day now experimenting and looking for root cause with no luck.
I've tried the other 2.4GHz interface with no luck too.
I have no idea where to look anymore. What can be the root cause?