Hello, my english is very bad but i will try help you.
Ful-duplex only work in UDP conecctions with very luck,you know that,no?with TCP you can have failover and half-duplex!!
Now:
First: You know how configure ospf in both side?
The idea is configure the " interface cost" for create full duplex:
site 1-ospf site-2-ospf
---------------- -----------------------
wlan1-cost-10<<----------------------------------->>wlan1-cost-100
wlan2-cost-100<<.................................>>wlan2-cost-10
In ospf-settings mark "redistribute coneccted routes"=as type 1;and put a "router id":1.1.1.1 for example and 1.1.1.2
If you want create a new area o use backbone,
You create in /ospf/interface static wlan1 and wlan2 and theirs cost in both side.
In "network tab" put your config network,
Then cross your fingers and pray!!!!!
This is my best explanation in English, in Spanish can be much more specific and accurate.
Best regards,
Hola, necesito tu ayuda con respecto a esto, como puedo comunicarme con vos lo antes posible?
Muchas gracias ante todo