Question1
below your link data is only installed one 3X3 minipci card at RB800.
But CPU Load is 51% during Speed test.
If install 4 minipci card(3X3), CPU load will be very high.
then I think throughput will be quite low.
I worry two things
1. High CPU Load may cause of low throughput
2. 3X3 X 4unit may cause RF interference and it occur low throughput.
did you have test or data about these related test?
My expecting usage is 1:1 or 1:1:1 or 1:2:1 like below picute. Question2
Commonly TCP throughput is more higher then UDP. But linked test result is UDP is more high.
I don't know why..
Question3
Which company's minipci card used? PCI express? or MINIPCI?
Can you recommand 3X3 minipci card for outdoor?
-----------------------------------------------------------------------------------------------------
Interesting tests. Here is our test of 3x3 MIMO on RB800:
Taken from here: http://mum.mikrotik.com/presentations/P ... 012-PL.pdf
Like macgaiver pointed out above, TCP loopback test is very misleading and doesn't show actual performance. You would need to test through the device with actual traffic, or iperf.
Further on in the article they show that doing this actually gives good results, as opposed to loopback test.