Hello.
Few days ago I upgraded to OS 5.21 and firmware 3.0
Omnitik became slow and after few hours I lost it.
Now when I plug the Poe, it does not beep/boot , but the led is on.
I heard I can recover it somehow.It's not yet fried !!...

Do i need to use netinstall ? i do not have any usb serial cable, how can I recover it? demounting and opening the plastic enclosure perhaps?

Hello

Have you tried with RESETING the hardware ??

unofrtunately nothing happens , after 10 or 30 seconds..
I open netinstall client and nothing happens...

did you connect cable from port 1 directly to your PC?
How can I connect cable from port 1 to my PC ? If I do that how can I switch on the Omnitik?I used a PoE and connected white cable into PC.

netinstall must be running on the same network,
Do you mean the same network of the one installed before crash on omnitik?

and the windows pc must have all firewall/antivirus programs disabled, and running with administrator privileges
this is fine


thanks

Yes I did plug it into PC and set Ip4 to : 172.18.1.5 , same subnet of crashed Omnitik.
I run Netinstall program and kept reset button for 30 seconds, but nothing is popping up...

Yes i did, but unfortunately no progress.
In fact when I switch the Omnitik , the board does not even beep...
Should I change the Ip perhaps...

Do you have any other suggestion?
CAn I record a short video , perhaps I do smth wrong?

regards

i can't manage to upload it.
Can I post it on my webpage?

If you have anather interface in your computer you must disable it (for example wifi card)
You can have only one card enabled at the same time if you usage netinstaler

ok let me try

yes, wireless off and netbootin and server enabled with 172.18.4.1
any suggestions?

looks like no eth is enabled,

do you think i can send the omnitik to you somehow?
Can we try again?

Oh my GOD!
The same problem have been happened to me, too. Today I just purchased a new OmniTik 5U-Hnd. It seemed that work without problem, but just after I upgrade and reboot to OS v5.22 , IT IS DEAD!!!!!
No LED turn on except for power. I test any methods to reset it. I even open apart the case and hold the internal reset button for more than 2 minutes but nothing happened.
Only the power LED is turned on all over the time, and if listen very carefully, I hear very slow tiny tick sound from buzzer every 12seconds, just it!

I wake all of the night, and can't find any solution. How can I tell it to my customer?

Please help me Normis, I have to done my job.

if you find any solutions, please let me know.
thanks

if you find any solutions, please let me know.
thanks

Ok. Finally I uninstalled my antivirus/firewall app (NOD32) and restart the laptop. Wow! NetInstall works and I upgrade Omnitik's OS. Hope it could help you too.

thanks a lot, but i dont have any antivirus installed..

maybe u have firewall on