Hello.
I recently changed ubnt nanos to mikrotiks SXT on one link 'cause I need more bandwidth.
Ubnt worked perfectly but with STX I got a problem.
One way signal is worse then the other. 98% and 25-33% respectively.
About 64 and 67 dBm requency signal strenth. Clear LOS. About 600 m distance.
I tried to change frequency several times - no result.
Any suggestions ?
RGDS
Re: 2 SXT ppp - one way signal is bad
1) Install RouterOS 6.7 on both SXT
2) in 1st SXT in terminal digit: /interface wireless export compact file=device1
3) Put the file device1.rsc from SXT in PC
4) in 2st SXT in terminal digit: /interface wireless export compact file=device2
5) Put the file device2.rsc from SXT in PC
6) open each file with notepad, or similar, remove sensible data (password), and post both code in the forum.
7) Wait for users help (also my).
2) in 1st SXT in terminal digit: /interface wireless export compact file=device1
3) Put the file device1.rsc from SXT in PC
4) in 2st SXT in terminal digit: /interface wireless export compact file=device2
5) Put the file device2.rsc from SXT in PC
6) open each file with notepad, or similar, remove sensible data (password), and post both code in the forum.
7) Wait for users help (also my).
Re: 2 SXT ppp - one way signal is bad
...
Last edited by rextended on Mon Mar 20, 2023 5:29 pm, edited 2 times in total.
Re: 2 SXT ppp - one way signal is bad
Here comes configs
other end
Code: Select all
# jan/03/1970 00:11:48 by RouterOS 6.10
# software id = BKEI-2540
#
/interface wireless
set [ find default-name=wlan1 ] band=5ghz-onlyn channel-width=\
20/40mhz-ht-above disabled=no frequency=5090 frequency-mode=superchannel \
l2mtu=2290 mode=bridge nv2-preshared-key=XXX nv2-security=enabled \
scan-list=5090 ssid=XXX wireless-protocol=nstreme
/interface wireless nstreme
set wlan1 enable-nstreme=yes
/interface wireless security-profiles
set [ find default=yes ] supplicant-identity=MikroTik
Code: Select all
# jan/03/1970 00:11:48 by RouterOS 6.10
# software id = BKEI-2540
#
/interface wireless
set [ find default-name=wlan1 ] band=5ghz-onlyn channel-width=\
20/40mhz-ht-above disabled=no frequency=5090 frequency-mode=superchannel \
l2mtu=2290 mode=bridge nv2-preshared-key=XXX nv2-security=enabled \
scan-list=5090 ssid=XXX wireless-protocol=nstreme
/interface wireless nstreme
set wlan1 enable-nstreme=yes
/interface wireless security-profiles
set [ find default=yes ] supplicant-identity=MikroTikRe: 2 SXT ppp - one way signal is bad
Thank you this is what I needed.
One thing though
It seems that I always loose all contact with the units as soon as the bridge comes up, is that avidable ?
One thing though
It seems that I always loose all contact with the units as soon as the bridge comes up, is that avidable ?