hi everybody
i have two sxt 5phnd and configured as point to point link but distance between two sxt is about 80 or 90 m
should i decrease TX power ?
and please advice me anythings that i should do
thanks very much
Yes it very short range decrease tx power to have signal between -50 and -60 in registration table.hi everybody
i have two sxt 5phnd and configured as point to point link but distance between two sxt is about 80 or 90 m
should i decrease TX power ?
and please advice me anythings that i should do
thanks very much
It is the some functionality make layer 2 bridge.Thanks alot
I change tx power from default to card rate = 8
Is this true ?
And another question is about link configuration
I setup one sxt as bridge and another one as station bridge
But in some document says set on side as bridge and another
Side station wds
Could you plz whats difrence between them
Really thank you