Hello,
I have a problem again with NV2 thruput.
Setup is the following:
Internet-PC router-CRS-SAF 24GHz Link-RB1100AH-Netmetal (921UAGS-5HPacT) everything is connected with GE
wireless ~20km link
911G-5HPnD as CPE

from CPE to RB1100AH (connected to CRS with GE) i can measure ~70mbps (on 20MHz ch bandwidth) that is OK.
from PC connected to CPE, i cannot measure more than 40mbps to speedtest.net or (local)speedtest.net(mini).

I'm sure this problem is related to RB's gigabit port NOT connected with Gigabit.
There is around 300meter from CPE to router (via fiber, what is 100mbps).
I would be pleased to have a solution for this, other than replace fiber converters or 911G to something with FE port only.

Thanks!

Hello,

old thread but forever a problem .
Try to set the ethernet port of the RB911G to Flow control ON or auto.

Try also to set 911G-5HPnD CPE ethernet interface queue to ethernet default (not only hardware queue)