i have ac wifi link .in low bandwidth i have no problem with ping time and packet lost
but when trrafic go up ping time go around 40 ms and i have lot of packet lost.
there isnt any problem when is use bandwidth test between wireless(about 200M/200M) but in each side i have ccr that connected to these wireless.when i test bandwidth from ccr to another ccr bandwidth go down near 40M/40M
i think wireless queued my trrafic but my queued is defalut.how should i repare it?
thank u

i have ac wifi link .in low bandwidth i have no problem with ping time and packet lost
but when trrafic go up ping time go around 40 ms and i have lot of packet lost.
there isnt any problem when is use bandwidth test between wireless(about 200M/200M) but in each side i have ccr that connected to these wireless.when i test bandwidth from ccr to another ccr bandwidth go down near 40M/40M
i think wireless queued my trrafic but my queued is defalut.how should i repare it?
thank u

i have this problem too
there isn't any problem with bandwidth test on UDP (420 mpbs one direction and 200/200 both ) .... TCP speed test around 120 - 140 mbps ...
CCR1036(ether2)______ RB911G-5HPacD+Dish mANT30 < - - - - - - -2KM FLOS - - - - - > Dish mANT30+ RB911G-5HPacD______AHX2(ether11)

but when real users traffic go up ping time of wireless go around 20-50 ms

i think Queue Type problem !

Have you set "only hardware queue" on wireless interfaces?


Gesendet von meinem HTC Flyer P510e mit Tapatalk 2

Have you set "only hardware queue" on wireless interfaces?


Gesendet von meinem HTC Flyer P510e mit Tapatalk 2

no ... we test sfq and multi-queue-ethernet-default

Use NV2 and try what ever interface queue works best for you.

hello
i use nv2 but bandwidth is lower and have ping time problem. i use nstream too.nstream ping time is very good but bandwidth is 20%lower than ac
i tested all queue type.but i have problem too